20170713160730-4736

Betaflight BLHeli_32Bit 35A ESC, an ESC that supports DShot1200

Betaflight new member BLEeli_32 ESC has come, we call it Betaflight BLHeli_32 35A ESC.

This ESC is a collaboration between FPVMODEL, Betaflight, Airbot and BLHeli.

Features and Specifications

  • Built in Current Sensor
  • Voltage Rating: 2S-6S
  • Current Rating (burst): 35A (45A)
  • TX pin available for future Telemetry support (connect to FC and you would get current sensing, motor RPM, ESC temperature etc)
  • DShot1200 support
  • Programmable RGB LED
  • Weight: 4.6g

Components

Apart from the ESC, it also comes with several electrical wires, two 16AWG Silicon wires for power, three 20AWG wires for signal and one 26AWG red wire. All these wires are 10cm long.

ESC Dimension

  • Length: 37mm (including the signal tab), 34mm (excluding the signal tab)
  • Width: 16mm
  • Height (thickest part): 7mm

A new additional setting”LED Control” in BLHeliSuite GUI, it is made to configure the colour of the LED on the ESC.

 

At the moment, it’s not doing anything fancy, it’s simply just a On/Off indicator: when the ESC is being powered the LED turns on.

Wish you good performance with Betaflight BLHeli_32 35A ESC.

 

 

 

KL-EX90

X-Racer KL-EX90 Micro Racing Quad, a light frame built for micro class FPV racing

Belong to series X-3Racer, KL-EX90 micro racing quad is another mini quad for FPV racing. Unlike the former X-Racer X-1 mainly designed for first users and children, KL-EX90 is one professional frame,  a 2″ propeller 90 class airframe for micro class FPV racing.

It weights 106 grams with a  2S 550mAh lipo battery. One important thing lies here: in terms of its small in size and light weight under 250g, you do not need to register with FAA if you are from the United States to fly the KL-EX90.

Compact design, suitable for both indoor and outdoor FPV. Equipped with F3 Flight Controller, 4-in-1 ESC,  powerful 1105-7500kv motors, Runcam Micro Swift FPV camera, Dragonfly 25mw 48ch vTX and LED light, all these have made the KL-EX90 perfect for both LOS and FPV flyers.

KL-EX90 uses reputable Flycolor RAPTOR S-Tower of F3 FC and 4-in-1 BLHeli_S 2-3S ESC gives you extremely good stability and flight performance.

Use Runcam Micro Swift, the worlds smallest and lightest CCD professional camera. It has the same performance to the well-known Runcam Swift and Swift Mini.

Worried about it may be hurtful and violent?

No worry!  Look! They also wear protection cover. It may reduce damage to your KL-EX90 in case of a hard crash.

Features:

  • Small in size and light in weight. All-up-weight is 106 grams only with a 2S 550mAh lipo battery. Do not require the hassles of getting it registered with the FAA if you are from the United States.
  • 2s / 3s lipo. Excellent power with just a 2S battery, even more powerful with 3S. It gives you very high speed, very precise and rail-like handling.
  • Fast as other larger racing quads. Our team pilot Ka Kei Leung finished the drone race at WMC 2017 in 9.65 sec.
  • Use Runcam Micro Swift, the worlds smallest and lightest CCD professional camera. It has the same performance to reputable Runcam Swift and Swift Mini.
  • The reputable Flycolor RAPTOR S-Tower of F3 FC and 4-in-1 BLHeli_S 2-3S ESC gives you extremely good stability and flight performance.
  • Equipped with powerful micro Dragonfly MC1105 brushless motors. Works great with Gemfan BN2035 propellers and Flycolor RAPTOR S-Tower.
  • A Dragonfly 25mw 48ch Vtx with protective coating is inlcuded to give an even more aero dynamic low profile design for the video transmission.
  • The flight controller is with built-in OSD.
  • The design is inspired by the champion KL200Race racing drone. Much smaller in size, but gives you the same flying experience of professional 200 and 210 class racing drones.